TMS zl Management and Configuration Guide ST.1.2.100916

7-55
Virtual Private Networks
Configure an IPsec Client-to-Site VPN
10. Click Save.
Create an IPsec Policy for a Client-to-Site VPN
This section explains how to configure an IPsec policy for a basic client-to-
site IPsec VPN. The IPsec policy selects traffic between local IP addresses
that are accessible to the remote users and the remote users. It includes
settings that will be negotiated during IKE phase 2.
For client-to-site IPsec VPNs, it is generally recommended that you use IKE
mode config. However, some IPsec clients (such as IPSecuritas VPN clients)
do not support the TMS zl Module implementation of IKE mode config. Decide
now whether you will use IKE mode config. Various settings depend on
whether you will use this feature.
Follow these steps to create the IPsec policy:
1. In the left navigation bar of the Web browser interface, click VPN > IPsec.
2. Click the IPsec Policies tab.
Figure 7-44. VPN > IPsec > IPsec Policies Window
3. Click Add IPsec Policy.