TMS zl Management and Configuration Guide ST.1.2.100916

7-59
Virtual Private Networks
Configure an IPsec Client-to-Site VPN
Figure 7-46. Example IPsec Client-to-Site VPN
8. For Traffic Selector, configure these settings:
a. For Protocol, specify the protocol for traffic allowed over the VPN:
– Any—Any IP protocol. Select this option when you want to select
all traffic between local and remote endpoints.
– TCP or UDP—Select this option in conjunction with a local port to
allow remote clients to access only specific services in the local
network.
– ICMP—Select this option when you want to select only ICMP
traffic.
– IP Protocols—Select one of these Layer 3 protocols, which are
listed by their IANA IP Protocol numbers.
Service objects and service groups will not appear in this list.
b. For Local Address, specify the IP addresses for all local endpoints to
which remote users are allowed access (indicated by 2 in the example
figure).
Do one of the following to specify addresses:
– Typically, manually type an IP address, IP address range, or
network address in CIDR format.