TMS zl Management and Configuration Guide ST.1.2.100916

7-199
Virtual Private Networks
Configure a GRE Tunnel
Move on to the next task: “Create Access Policies for a GRE Tunnel” on page
7-203.
Configure RIP on a GRE Tunnel Interface
This section includes the most basic steps for configuring RIP on a GRE tunnel
interface. Often you must complete more steps such as redistributing con-
nected routes. For complete instructions for RIP configurations, see
Chapter 9: “Routing.”
1. Click Network > Routing and click the RIP tab.
Figure 7-163. Network > Routing > RIP Window
2. Select the Enable RIP check box.
3. Click Apply My Changes.
4. Click Enable RIP on an interface. The Enable RIP on Interface window is
displayed.