TMS zl Management and Configuration Guide ST.1.2.100916

7-321
Virtual Private Networks
GRE Examples
Figure 7-277. Enable OSPF on a Interface Window
5. Accept the default values for the remaining options.
6. Click OK.
7. Click Save.
Configure Other OSPF Settings for Site B
Again, If you have not configured other OSPF settings, you must do so now.
Enable OSPF, set a unique router ID, and redistribute any routes that you want
the module to advertise through the tunnel. You should also configure any
STUB or NSSA areas that you require. In this example, the local network at
site B is a stub area. Finally, enable OSPF on the VLAN interface for the local
network.
Note Remember to verify that the module does not receive the best route to the
remote tunnel gateway over the tunnel itself. In this example, you avoid this
problem because you have already configured a static route to the remote
tunnel gateway with a low administrative distance.