TMS zl Management and Configuration Guide ST.1.2.100916

7-353
Virtual Private Networks
Configure Global IPsec Settings
• Select the Handle ICMP error messages check box to have the TMS zl
Module accept incoming ICMP error messages.
By default, this check box is selected.
5. For Maximum SA per Policy, type the maximum number of SAs that can be
established using each IPsec policy.
The valid range is 2 to 10000. The default is 10000. Each connection to a
remote client requires 2 SAs (one inbound and one outbound).
Note that although you can define up 10000 SAs per policy, only 4800
sessions can be open concurrently. (See “Introduction” on page 7-6 for
more information about the number of IPsec connections supported.)
6. Select the Auto SA Revalidation check box to allow the TMS zl Module to
automatically revalidate SAs when the associated policy is changed or
when the time or bandwidth limit expires.
If you clear the check box, the TMS zl Module does not revalidate the SA
until a packet arrives for that SA (which might slow processing for that
packet). By default, the check box is selected.
7. For Minimum Packet Size for IP Compression, type a packet size in bytes.
When IP compression is enabled for an SA (as specified in the IPsec policy
advanced settings), all packets of this size or larger will be compressed.
The valid range is 91 to 2147483647 bytes. The default is 1500 bytes.