TMS zl Management and Configuration Guide ST.1.2.100916

7-368

Virtual Private Networks

Configure an HP ProCurve VPN Client

This section includes step-by-step instructions for configuring an HP Pro-

Curve VPN Client to establish an IPsec connection to the TMS zl Module.

For the configuration to work, you must configure client-to-site IPsec settings

on the module as described in “Configure an IPsec Client-to-Site VPN” on

page 7-27. See “TMS zl Module Settings for the HP ProCurve VPN Client” on

page 7-377 for a table that shows all necessary settings.

Follow these steps to configure the HP ProCurve VPN Client:

1. If necessary, install the client on the endpoint.

2. Open the Security Policy Editor using one of these methods:

•In the Start menu, click Programs > ProCurve VPN Client > Security Policy

Editor.

• Right-click the ProCurve VPN Client icon in the system tray and click

Security Policy Editor.

Figure 7-312. Security Policy Editor Window