TMS zl Management and Configuration Guide ST.1.2.100916

7-388
Virtual Private Networks
Configure IPSecuritas (Macintosh VPN Client)
Figure 7-332. IPSecuritas—Connections > General Tab
11. Click the General tab.
12. For Remote IPSec Device, type the IP address at which the client reaches
the TMS zl Module.
Often, this is the same address that the module’s IKE policy specifies as
the local gateway. However, if NAT is performed on this module IP
address, you must specify the NAT address.
13. Configure the following settings, which correspond to the traffic selector
in the TMS zl Module’s IPsec policy:
a. For Local Side, select the Endpoint Mode:
– Host — Specifies the IP address of the client. You can specify an
IP address in the box that is displayed. If you do not, the client’s
IP address will be used automatically.
– Network — Specifies the subnet on which the client resides.
For Network Address, type the address of the subnet. For Network
Mask (CIDR), type the number of bits in the network mask.