TMS zl Module Installation and Getting Started Guide 2010-03

2-11
Getting Started
Initial Configuration
Boot the TMS zl Module to the Product OS
To boot the TMS zl module to the Product OS, complete the following steps.
1. From the Service OS context, enter the following. When asked if you
would like to reboot the module, type y:
hostswitch(services-module-C:HD)# boot product
Changing boot from Service OS to Product OS.
System will be rebooted. Do you want to continue [y/n]? y
Rebooting
2. You will be returned to the host switch’s CLI. To view the progress of the
reboot process, enter the following commands in succession:
hostswitch# show services C
hostswitch# repeat
You will continue to see updated output for the show services command. The
following shows an example of the output you might see. The Current status
information will vary, depending on the progress of the boot process.
Status and Counters - Services Module C Status
HP Services zl Module J9154A
Versions : A.01.06
Current status : booting
For more information, use the show commands in
services context
When the Current status is “running”, press any key to stop the execution
of the show services command.
3. Enter the Product OS context:
hostswitch# services C 2
The prompt should look like the following:
hostswitch(tms-module-C)#
You can now set up management access on the TMS zl module to begin
configuring the application’s features.
zlSM.book Page 11 Monday, March 1, 2010 11:42 PM