TMS zl Module Installation and Getting Started Guide 2010-03

C-6
Hardware Components
Replacing the Disk Drive
6. Using either side of the disk drive bracket, lift the disk drive out.
7. Install the new disk drive and slide it forward to engage the connector.
8. Re-install the four retaining screws.
9. Re-install the module into the switch.
10. Use an equal amount of pressure and push both extractor handles closed
to completely seat the module.
11. Tighten the retaining screws.
Figure C-5. Steps to Replacing the Module’s Disk Drive
1. 2.
3. 4.
Retaining Screws
Extractor Handles
Retaining Screws
Disconnected
zlSM.book Page 6 Monday, March 1, 2010 11:42 PM