TMS zl Module Installation and Getting Started Guide 2010-03

C-7

Hardware Components

Replacing the Flash Card

The following is the procedure for replacing the Flash Card in the TMS zl

module. The module may be removed while the switch is powered on. The

numbers in Figure C-6 correspond to the step numbers below.

1. Using either a flat-bladed or Torx T-10 screwdriver loosen the retaining

screws securing the module.

2. Using the extractor handles, pull the module out from the slot and turn

it over.

3. Slide out the old flash card by applying slight pressure to the top of the

flash card.

4. Position the new flash card properly and slide it in being careful not to

bend any connector pins.

5. Re-install the module into the switch.

6. Use an equal amount of pressure and push both extractor handles closed

to completely seat the module.

7. Tighten the retaining screws.

1. 2.

Retaining Screws

Extractor Handles

zlSM.book Page 7 Monday, March 1, 2010 11:42 PM