TMS zl Module Installation and Getting Started Guide 2010-03

D-2

Software Components

Updating Product OS

There are two ways to update the Product OS:

■ via FTP: used when the HP ProCurve update server is accessible from the

module

■ via USB: used when the HP ProCurve update server is not accessible from

the module

Note The process of updating the Product OS is faster if the switch is accessed via

Telnet or SSH; the serial console slows down the writing of characters to the

screen, causing a significantly slower installation speed, especially if the

switch console is run at the default 9600 baud.

If the TMS zl module is already running a version of the Product OS, reboot

into the Service OS before continuing:

hostswitch# services c 1

This assumes the module is in slot C.

hostswitch<services-module-C># boot service

Changing boot from Product OS to Service OS.

System will be rebooted. Do you want to continue [y/n]? y

Rebooting

Updating Product OS via FTP

1. Ensure that port 1 of the TMS zl module is an untagged member of a VLAN

that connects to the FTP server. The following commands assume the

TMS zl module is installed in slot C and VLAN 1 connects to the FTP server

on the network.

hostswitch# configure

hostswitch(config)# vlan 1 untagged c1

2. Enter the Service OS CLI.

hostswitch# services c 1

zlSM.book Page 2 Monday, March 1, 2010 11:42 PM