TMS zl Module Installation and Getting Started Guide 2010-03

1-3
Hardware Installation
Installing the Module
Installation Procedure
1. Use a Torx T-10 or flat-bladed screwdriver to unscrew the screws in the
cover plate over the slot where the module is to be installed. Remove the
cover, and store the cover plate for possible future use.
2. Hold the module by its bulkhead—taking care not to touch the metal
connectors or components on the board.
3. Open the extractor handles.
4. Insert the module aligning with the guides in the slot, and slide it into the
slot until it is fully inserted.
5. Once the contacts have engaged, use the extractor handles to seat the
module completely.
6. Tighten the screws.
Figure 1-2. Module being installed
The procedure to replace or remove a TMS zl module is described on page C-4
in the Web version of this document at www.hp.com/go/procurve/manuals.
Appendix C also describes the procedure to replace the module’s hard drive
and the flash card.
Insert module into the guides
and slide in until fully
inserted.
Open extractor handles
zlSM.book Page 3 Monday, March 1, 2010 11:42 PM