TMS zl Module Planning and Implementation Guide 2009-08
Table Of Contents
- Contents
- Glossary of Acronyms and Abbreviations
- 1.0 Purpose
- 2.0 Intended Audience
- 3.0 Objectives
- 4.0 Prerequisites
- 5.0 Skills
- 6.0 The HP ProCurve Threat Management Services zl Module
- 7.0 Common TMS Security Control Points
- 8.0 Deployment Considerations
- 9.0 Installation and Preparation of the TMS zl Module
- 10.0 Configuration of the TMS zl Module
- 11.0 Using multiple HP ProCurve Threat Management Services zl Modules
- Appendix A – Additional References
- Appendix B – Sample Company Information Assets Spreadsheet
- Sample “Information Assets” tab (See Embedded “Company Information Assets” Microsoft Excel 2003 spreadsheet)
- “Server Network Details” tab (See Embedded “Company Information Assets” Microsoft Excel 2003 spreadsheet)
- “TMS Zones” tab (See Embedded “Company Information Assets” Microsoft Excel 2003 spreadsheet)
- “Firewall Rules” tab (See Embedded “Company Information Assets” Microsoft Excel 2003 spreadsheet)
- /Sample “Company Information Assets” Microsoft Excel 2003 spreadsheet
- Appendix C – Information Gathering Tools
- Appendix D - Updating Switch Software
- Appendix E – Emergency Recovery Process
Page 57
2. For Server Address, type the IP address or FQDN of an SNMPv3
server. For example, if you are using PCM+, you would enter the IP
address or FQDN of the server running PCM+.
3. For Username, type the SNMPv3 username for an account on the
server. This must match the username configured on the SNMP server
(such as PCM+).
4. For Auth Passphrase, type the authentication passphrase for the
account on the server. This must match the authentication passphrase
configured on the SNMP server (such as PCM+).
5. For Auth Protocol, select the authentication protocol used on the
SNMPv3 server: MD5 or SHA. Again, this must match the setting
configured on the SNMP server (such as PCM+).
6. Optionally, for Privacy Passphrase, type the privacy passphrase for
the account on the SNMP server, if this setting is configured on the server.
7. Optionally, for Privacy Protocol, select the privacy protocol used on
the server: DES or AES. You would configure a privacy protocol if one is
configured on the SNMP server.
8. Click OK.
9. Click Save.
9.2.5.6 Configure SNMP
The TMS zl Module allows some remote management through SNMPv1/v2c
or SNMPv3. For example, you can configure SNMP so that the module can be
managed by PCM+. If you are going to allow remote management through
SNMP, make sure that you configure the parameters on the TMS zl Module to
match those configured on the SNMP server.
To configure SNMP settings, select System > Settings and click the SNMP
tab.