TMS zl Module Release Notes ST.1.0.090603

Known Issues
Release ST.1.0.090213
Related PRs:
PR_0000000665
PR_0000001794
PR_0000002068
PR_0000002252
PR_0000002253
PR_0000002254
PR_0000002424
PR_0000002613
PR_0000003824
■ PR_0000000906 — When the Web browser interface of the TMS zl Module is left at the login
screen without the user logging into the TMS zl Module, the inactivity timer still applies,
resulting in the user having to go back to the login screen manually. The inactivity timer
should only apply once a user has logged in, but instead applies at all times.
■ PR_0000000961 — The initial login banner text of the Web browser interface in the TMS
zl Module differs in size depending on whether the user is accessing it with HTTP or HTTPS.
While noticeable, this difference in size does not impair functionality.
■ PR_0000001044 — From the TMS zl Module CLI, when a TMS zl Module is operating in
Routing Mode using OSPF, the command show ip ospf neighbor has an output that is not the
same as a ProCurve switch that is running OSPF. Important information about OSPF
neighbors is still shown, how the information that is shown is different from the switch.
■ PR_0000001143 — The options for VLAN IPv4 functionality change depending on how a
command is accessed. For example, vlan <id> ip options are different than going into the
VLAN context via vlan <id> and then typing ip.
Example:
ProCurve Switch(tms-module-D:config)# vlan 20 ip
address Set IP parameters for communication within an IP network.
igmp Enable IGMP on the VLAN.
pim-sparse Enable PIM-SM on the device.
ProCurve Switch(tms-module-D:config)# vlan 20
ProCurve Switch(tms-module-D:vlan-20)# ip
address Set IP parameters for communication within an IP network.
igmp Enable IGMP on the VLAN.
rip Configure RIP on the VLAN.
ospf Configure OSPF settings.
pim-sparse Enables PIM-SM on the VLAN.
The impact to the user is that some commands cannot be typed in a single line and the VLAN
configuration context must be entered in order to configure some items.
27