TMS zl Module Release Notes ST.1.0.090603

Known Issues
Release ST.1.0.090213
■ PR_0000016231 — Some log entries for warning logs and information logs have messages
that are truncated in the log viewer. The most log messages are not truncated and those that
are contain enough information that a user can tell what they are about. However, the
messages have more information in them than can be displayed.
■ PR_0000016539 — When using the TMS zl Module CLI, the radius-server help command
gives options that are not available.
■ PR_0000016546 — A TMS zl Module that incorrectly has duplicate IP addresses for its
VLANs may cause the TMS zl Module SNMP daemon to restart, which may hide the actual
problem from a user. While it is incorrect to have duplicate IP addresses, this may occur, and
the SNMP daemon restart may send the administrator down the wrong troubleshooting path.
■ PR_0000016812 — When a user incorrectly logs into a TMS zl Module resulting in an
authentication failure, if the TMS zl Module is setup to send traps, it will send an
authentication failure trap. However, the trap does not contain the user's IP address or the
username.
■ PR_0000016892 — When the local log contains more than 10,000 entries, the oldest entries
(after the 1,000th entry) are displayed in a wrong position.
Steps to reproduce:
1. Get more than 10,000 entries in the local log
2. Either export the local log or, in the Web browser interface, set the number of entries per
page to 500 and go to page 6.
■ PR_0000018145 — In the Web browser interface, if a VLAN is added with an invalid IP
address in the range 224.0.0.0 - 254.255.255.255, an error is returned stating:
VLAN could
not be added. Failed to add VLAN IP address
, but the VLAN is actually added, but
not associated to any zone. In the CLI, the error message only states:
Error: Failed to
set VLAN IP address:
■ PR_0000018197 — The Web browser interface Help incorrectly states the number of VLAN
associations supported as 21. It should be 19.
■ PR_0000000999 — In the Web browser interface, Firewall > Access Policies, if a user deletes
all the rules in an access policy, the Web browser interface doesn't remove the empty policy
until a screen refresh is done. This is a visual issue only, the policy has actually been removed.
■ PR_0000002379 — In the Web browser interface, when adding a Service Object, if the
Service Object already exists, an error message is displayed. The error message refers to an
Address Object instead of a Service Object.
■ PR_0000002387 — In the TMS zl Module CLI, when creating a Service Object, the value of
zero cannot be set as a protocol number although zero is a valid protocol number.
37