TMS zl Module Release Notes ST.1.0.090603

Known Issues
Release ST.1.0.090213
■ PR_0000007533 — If the TMS zl Module is in monitor mode, the IDS logs incorrectly show
zones Internal and Zone6 in the logs for data and management. These zone references are not
correct and should be ignored.
■ PR_0000011929 — When in monitor mode and using the TMS zl Module CLI, if you add
an management IP address, the CIDR format of IP-Address/mask is not accepted and you
must enter the IP address and Subnet Mask as separate values.
■ PR_0000014582 — In monitor mode, the CLI command ips help does not reflect the
commands that are actually available in monitor mode as opposed to routing mode.
■ PR_0000015837 — In monitor mode, the management VLAN can be deleted from the
switch. In routing Mode, the user is prevented from making this change on the switch.
Example:
Preconditions: monitor mode, management VLAN and management IP address have been set. In
this example, the management VLAN is 30.
Delete the management VLAN from the switch CLI.
ProCurve Switch (tms-module-D:config)# no vlan 30
An error message should be displayed preventing the deletion of the VLAN due to its use by the
TMS zl Module. A user is not prevented from performing this action and the VLAN is deleted. As
a result, the Web browser interface of the TMS zl Module can't be accessed because the
management VLAN has been deleted
■ PR_0000017758 — In monitor mode, when IPS full inspection is turned on and the FTP
ALG is turned off, sending an FTP copy of the startup configuration to the network fails with
a broken pipe error.
43