TMS zl Module Release Notes ST.1.2.100916

95
Known Issues
Release ST.1.0.090213
■ PR_38217 — When setting up an IPsec policy with a Key Exchange of Manual, it is possible
to specify an SPI number that is already in use by another IPsec policy and it would not be
detected. Duplicate SPI numbers across IPsec policies are not allowed and an error needs
to be displayed.
■ PR_38218 — Cannot change a bypass or ignore policy to apply with key exchange method
manual. Workaround: Delete the policy and add a new one.
■ PR_38226 — Changing a bypass or ignore IPsec policy to apply shows an erroneous key
exchange method. Workaround: Delete the policy and add a new one.
■ PR_38228 — A misleading error occurs when the traffic selector's IP range starts or ends
with 255.
■ PR_38229 — IPsec policy advanced settings are displayed incorrectly after the default
settings are changed and then edited in the Web browser interface.
■ PR_38231 — On the advanced settings screen (VPN > IPsec > IPsec Policies) Enable fragment
before IPsec cannot be disabled.
■ PR_38232 — Moving an IPsec policy to another position may not set it in the desired
position. Workaround: Delete the policy and add a new one in the correct position.
■ PR_38238 — A misleading error occurs when importing an invalid certificate file.
Workaround: Import a valid file.
■ PR_38240 — Cannot import IPsec Certificates (intermittently fails) from the Web browser
interface (VPN > Certificates > IPsec Certificates).
■ PR_38887 — VPN connections truncate local gateway addresses, preventing a user from
seeing all the information for an established tunnel.
High Availability (Active/Standby)
■ PR_7372 — From the TMS zl Module CLI, the high-availability command does not accept
CIDR notation.
ProCurve Switch 5406zl(tms-module-D:config)# high-availability ip 192.168.1.1/24
Invalid input: 192.168.1.1/24
■ PR_8257 — On the HA configuration page in the Web browser interface, if you change the
Multicast IP and then refresh the HA page, you lose your changes. You must save and reboot
for the changes to take effect.
■ PR_9541 — The switch Web browser interface config link directs a user to the HA IP address
instead of the TMS zl Module’s management IP address.
Example:
There are two TMS zl Modules setup in Active/Standby mode for High Availability