WESM xl Getting Started Guide 2007-08

14
Getting Started
Verify 5300xl Switch Software
Start a console session. The following CLI commands show the switch
software version. The ProCurve 5300xl Switch software must be version
E.10.30 or later (E.10.60 or later is recommended).
Step 2 - Boot up the system.
1. After powering on the wireless services-enabled Switch 5300xl, LEDs
blink as follows:
• LEDs on the top of the 5300xl light immediately. After the system is
initialized, only the LEDs associated with the modules that are
installed remain lit.
• After several seconds, the multiple LEDs on the PoE xl Module and
on the 10/100-TX xl module light and blink frequently.
• On the Module, the ’Module Activity’ LEDs light, indicating the
percent of the start-up process completed. The ’Module Fault’ LED
also lights at this time. When self-test has passed,
– the ’Module Fault’ LED goes out, the 80% LED light goes out, and
– the ’Module Ready’ LED blinks for a few seconds, as the Module
and its applications initialize.
– When the ’Module Ready’ LED is solidly lit, the wireless services-
enabled Switch 5300xl and Module are ready to use.
2. Simultaneously, the connected radio ports power-up, and their LEDs blink
as follows during start-up operation:
• The amber and green LEDs immediate light for several seconds.
• Then, the green light goes out and the amber lights blinks
approximately once per second.
– If the Country Code is not set in the Module, the amber light
continues to blink, with the green light out. This radio port is in
the unadopted mode.
– If the Country Code is set, then the start up process will continue
as described in the next two bullets.
ProCurve# show version
Image stamp: /sw/code/build/alpmo(lor)
Jan 23 2007 15:41:58
E.10.30
255
Boot Image: Primary
ProCurve#