WESM xl Getting Started Guide 2007-08

Getting Started

• After the amber light blinks for approximately 5 seconds, both LEDs

solidly light for about 5 seconds.

• Then, both the LEDs blink about once every 5 seconds, indicating that

the Radio Port is adopted and ready for use.

3. For more details on the LEDs activity of the radio ports, please refer to

the Radio Port Install Guides for the respective models (210, 220, and 230).

Step 3 - Determine Module IP address.

The Module IP address is set automatically by a DHCP server (default) or by

a manual setting via CLI commands.

1. By default, the Module obtains an IP address from a DHCP server. These

DHCP services may be provided from a network provider or from a local

DHCP server. To determine the IP address of the Module, connect a PC

or terminal to the console port on the front of the ProCurve Switch 5300xl

and open a console session. The following is a sample start up screen.

Connected at 9600 baud

HP J4819A ProCurve Switch 5308xl

Firmware revision E.10.30

RESTRICTED RIGHTS LEGEND

Use, duplication, or disclosure by the Government is subject to

restrictions

as set forth in subdivision (b) (3) (ii) of the Rights in Technical

Data and

Computer Software clause at 52.227-7013.

HEWLETT-PACKARD COMPANY, 3000 Hanover St., Palo Alto, CA 94303

We'd like to keep you up to date about:

* Software feature updates

* New product announcements

* Special events

Please register your products now at: www.ProCurve.com

Press any key to continue

ProCurve#