WESM xl Management and Configuration Guide WS.02.XX and greater

7-10

Access Control Lists (ACLs)

Configuring ACLs

To configure an ACL, you must complete these steps:

1. Create the list and select the ACL type.

2. Create a series of ordered permit, deny, or mark rules.

3. Apply the list to an interface.

Do not complete the final step if you are using a standard IP ACL for a function

other than controlling traffic. These functions include:

■ NAT—The ACL selects traffic for dynamic source NAT; you specify the

ACL in the NAT configuration. See Chapter 8: Configuring Network

Address Translation (NAT).

■ secure Network Time Protocol (NTP)—The ACL selects which hosts

are allowed to send specific types of NTP communications. See “Applying

ACLs to NTP Services” on page 2-146 of Chapter 2: Configuring the

ProCurve Wireless Edge Services xl Module.

Creating ACLs

To create an ACL, complete these steps:

1. Select Security > ACLs > Configuration.