WESM zl Management and Configuration Guide Supplement 2007-09

6
General Operating Rules with zl Switches
Related Publications
This supplement describes the setup and configuration of the ProCurve
Wireless Edge Services zl Modules in a Wireless Services-Enabled ProCurve
zl Switch. The focus is on Module operation as part of a zl switch. Other
documentation describes the operation of these Modules in providing wireless
services. The following manuals provide further information:
■ For information on the Module’s specifications, hardware features,
and installation, refer to the ProCurve Switch zl Modules Installation
Guide provided with the Module.
■ Additional information on the initial setup of the Modules in the zl
switch can be found in the Installation and Getting Started Guide
for your particular zl switch model.
■ For initial setup instructions with examples, see the ProCurve
Wireless Edge Services zl Modules Getting Started Guide provided
with the Module.
■ For detailed information and instructions on how to configure and
manage a Module and wireless services in your network, refer to the
ProCurve Wireless Edge Services zl Modules Management and
Configuration Guide.
The latest versions of these documents are available on the ProCurve
Networking Web site at www.procurve.com
(click on Technical support, then
Product manuals (all), and select your ProCurve zl switch model.).
General Operating Rules with zl
Switches
■ Use the show vlans command to check the maximum number of
VLANs allowed. Use the max-vlans <1-2048> command to change the
number, if required.
■ Shut down the Module
• before resetting or reloading the zl switch chassis
• before turning off the zl switch chassis.
• before removing the Module from the zl switch chassis.
See the shutdown command in “CLI Configuration Commands Overview and
Syntax” on page 28.