WESM zl Management and Configuration Guide Supplement 2007-09

Using zl Switch Features for the Module

The following switch authentication applications take precedence over LLDP:

■ 8021.X

■ Web Authentication

■ MAC Authentication

This means that if LLDP is currently overriding a port's static configuration,

and 802.1X authentication is enabled on the port, LLDP's override can be

superseded by an 802.1X override.

All three of the above authentication schemes take precedence over LLDP.

The show vlan <vid> CLI command list the ports being temporarily overridden

for a given VLAN, along with the application that is forcing the override.

Note When using Layer 3 adoption, any VLAN which has the IP address of the

Module may be used. Either the Module’s internal uplink port (<slot-id>UP)

or the internal downlink port (<slot-id>DP), but not both, must be a member

of this VLAN.

Automatic RP VLAN Operation Using LLDP

LLDP CLI commands available in the zl switch software provide automatic

VLAN creation (the Auto-VLAN) and memberships for both Module and switch

ports to enable radio port communications. These commands are enabled by

default and allow radio ports connected directly to PoE-enabled zl switch

ports to communicate with the Module without any manual configuration,

Use the show lldp auto-provision radio-ports command to display the settings

and status of auto-provisioning by the switch.

ProCurve(config)# show lldp auto-provision radio-ports

LLDP auto-provision Radio-Ports Support:

LLDP Radio Port Enable [Yes] : Yes

LLDP Radio Port suggested auto-vlan [2100] : 2100

LLDP Radio Port auto-vlan : 2100

LLDP Radio Port assigned ports : C1,C23

LLDP Global Enable [Yes] : Yes

ProCurve(config)#