WESM zl Management and Configuration Guide Supplement 2007-09

25
CLI (Command Line Interface)
Configuring the Module on the Network
By default, the Module uses DHCP to get an IP address. When the IP address
is assigned manually, be sure to configure a Default Gateway as required.
Use the following commands to configure an IP address manually.
Note “ProCurve” is used here as a generic prompt for all zl switches.
ProCurve# wireless-services <slot-id>
ProCurve(wireless-services-<slot-id>)#configure
ProCurve(wireless-services-<slot-id>)(config)#interface vlan1
ProCurve(wireless-services-<slot-id>)(config-if)# ip address <ip-addr>
where <slot-id> is the slot in the zl switch where the Module is installed,
<ip-addr> is either the IP address in CIDR notation (n.n.n.n/mask
bit number) or dhcp, which uses a DHCP client to obtain an IP
address.
If necessary, use the following command in the Config context to set or change
the default gateway:
ProCurve(wireless-services-<slot-id>)(config)#ip default-gateway <ip-addr>
where <ip-addr> is the numeric IP address of the default gateway, for
example 10.1.2.1.
show show Show running system information
support support Support commands
– telnet Open a Telnet connection
– terminal Set terminal line parameters
– upgrade Upgrade software image
– upgrade-abort Abort an ongoing upgrade
write write Write running configuration to memory or
terminal
Operator
(ProCurve>)
Manager
(ProCurve#)
Description