WESM zl Management and Configuration Guide Supplement 2007-09

26
CLI (Command Line Interface)
To display the Module’s IP address, you must first go to the wireless-services
context in the zl switch CLI, using the following command:
ProCurve# wireless-services <slot-id>
To show the Module’s IP address, enter
ProCurve(wireless-services-<slot-id>)# show ip interfaces
The following example shows the IP address assigned by DHCP to a Module
installed in Slot C of a zl switch:
Changing the Auto-Provision VLAN-Base
You may wish to use another VLAN as your suggested Auto-VLAN. This may
be done using the following command.
ProCurve (config)# lldp auto-provision radio-ports vlan-base <2-4094>
where <2-4094> is the suggested VLAN ID (VID) used when the Auto-VLAN
is created by LLDP auto-provisioning.
The following command changes the vlan-base used when the Auto-VLAN is
created to 120 instead of the default 2100.
ProCurve (Config)# lldp auto-provision radio-ports vlan-base 120
As illustrated below, the show lldp auto-provision radio-ports command displays
the new configuration of the vlan-base.
ProCurve(wireless-services-C)#show ip interface
Interface IP-Address Status Protocol
vlan1 10.100.50.10(DHCP) up up
vlan21 10.10.10.10 up up
ProCurve(wireless-services-C)#