WESM zl Management and Configuration Guide Supplement 2007-09

CLI (Command Line Interface)

Creating or Changing the Radio Port Auto-VLAN

You may wish to manually create or use another VLAN as the Auto-VLAN. This

may be done using the following command.

ProCurve (Config)#lldp auto-provision radio-ports auto-vlan <vid>

where <vid> is 2-4094. See Table 1, “Automatic VLAN Provisioning with

LLDP,” on page 13 for information on the changes that occur,

depending on the current state of the switch.

The following command changes the auto-vlan to 3200 instead of the default

2100.

ProCurve (Config)# lldp auto-provision radio-ports auto-vlan 3200

The show lldp auto-provision radio-ports command displays the new auto-vlan.

ProCurve(config)# show lldp auto-provision radio-ports

LLDP auto-provision Radio-Ports Support:

LLDP Radio Port Enable [Yes] : Yes

LLDP Radio Port suggested auto-vlan [2100] : 120

LLDP Radio Port auto-vlan : 2100

LLDP Radio Port assigned ports : C1,C23

LLDP Global Enable [Yes] : Yes

ProCurve(config)#