WESM zl Management and Configuration Guide Supplement 2007-09

CLI (Command Line Interface)

The no lldp auto-provision radio-ports auto-vlan <vid> may be used to delete the

radio port Auto-VLAN. See Table 1, “Automatic VLAN Provisioning with

LLDP,” on page 13 for information on the changes that occur, depending on

the current state of the switch.

Managing Module Configuration Files

The configuration files for the Wireless Edge Services zl Module and the

Redundant Wireless Services zl Module are stored on the Module, not on the

zl switch, which may be unlike other zl module accessories. An external FTP

or TFTP server must be used to back up and restore a Module’s complete

configuration. The switch does save a small subset of the Module’s

configuration that allows the switch:

■ to locate the full configuration file on the external FTP or TFTP server,

and,

■ to validate the configuration file using a checksum

For more information on configuring and managing configuration files on an

external FTP or TFTP server see the latest Management and Configuration

Guide for your Wireless Edge Services Module.

The stored subset of a Module’s configuration file appears in a

show running-config or show config command as uneditable text.

CLI Configuration Commands Overview and Syntax

Command Page

Switch Configuration Context

[no] lldp auto-provision radio-ports 29

[no] lldp auto-provision radio-ports auto-vlan <vid> 29

lldp auto-provision radio-ports vlan-base <2-4094> 29

wireless-services <slot-id>30

wireless-services <slot-id> reload 30

wireless-services <slot-id> shutdown 30

Wireless-Services Context

For a complete listing of the commands, please refer to the ProCurve

Wireless Edge Services zl Modules Management and Configuration

Guide.