WESM zl Management and Configuration Guide Supplement 2007-09

29
CLI (Command Line Interface)
Switch Config Context Commands and Syntax
Syntax: [no] lldp auto-provision radio-ports
Enables ports connecting to a radio port, discovered
using LLDP, to be automatically placed into the Auto-
VLAN. LLDP must be enabled on the switch and the
port.
When enabled (the default) the Auto-VLAN (default
2100) is created when a Module or radio port is
detected. The Module downlink port, <slot-id>DP, is
placed in the Auto-VLAN as a tagged member; the
Module’s uplink port, <slot-id>UP, is placed in the
DEFAULT_VLAN (VLAN 1) as a tagged member.
The no form can be used to disable this automatic port
placement.
Syntax: [no] lldp auto-provision radio-ports auto-vlan <vid>
Creates the Auto-VLAN with the specified VLAN ID
(VID) if it does not already exist and if the specified
VID does not already exist.
If the radio port Auto-VLAN already exists, all ports in
the current Auto-VLAN are moved to the new Auto-
VLAN. If the previous Auto-VLAN then contains only
downlink ports (<slot-id>DP) or is empty, it is deleted.
The no lldp auto-provision radio-ports auto-vlan <vid>
command may be used to delete the auto-vlan.
Syntax: lldp auto-provision radio-ports vlan-base <2-4094>
Sets the suggested Auto-VLAN’s ID (VID) for the Auto-
VLAN created by the switch when a Wireless Edge
Services zl Module or radio port is discovered and auto-
provisioning is enabled (the default). If the VID is
already in use, the next available VID following the
suggested value is used.
The default suggested VID is 2100.