WESM zl Management and Configuration Guide WT.01.03 and greater

2-66
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
Figure 2-35. Checking an RP’s Bootloader Code Through the Module’s Web
Browser Interface
With the new bootloader code, the RP can complete Layer 3 adoption. You
can now install the RP in its final location, and as long as you set up other
requirements described below, the RP will be adopted at Layer 3.
2. On your DHCP server, you can create a fixed configuration specifically
for the RP, or you can add option 189 to a pool already configured for other
stations.
You can easily allow the RP to use the same pool as other stations. The
DHCP server does not send the 189 option unless the device requests it.
If, however, for whatever reason, you want to create a fixed configuration
for the RP, you should specify the RP’s Ethernet MAC address as the client
ID. You can find this MAC address on the undercarriage of an RP 210 or 230
or the top face of an RP 220.
Boot code