WESM zl Management and Configuration Guide WT.01.03 and greater

2-70
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
Figure 2-37. Verifying Layer 3 Adoption in the Device Information > Radio Adoption
Statistics
The screen should list the Layer 3 RP just as it lists other RPs. However, the
IP Address field shows the Layer 3 RP’s IP address. (This field shows N/A for
Layer 2 RPs.)
Note The IP address is for informational purposes only. For example, you can ping
the RP at this address, but you cannot attempt to access or manage the RP.
Automatic or Manual Adoption of RPs
Once an RP can transmit traffic to the Wireless Edge Services zl Module, the
module can detect and adopt it. Automatic adoption simplifies deployment,
especially if your network includes many RPs. After the Wireless Edge Ser-
vices zl Module adopts an RP, it sends the radio adoption default configuration
to it. You can then customize settings for certain RPs. (To learn how to
configure RP settings, see Chapter 3: “Radio Port Configuration.”)
This RP was
adopted at Layer 3