WESM zl Management and Configuration Guide WT.01.03 and greater

4-76
Wireless Local Area Networks (WLANs)
Configuring a WLAN
Figure 4-44. Global WLAN Settings Screen
3. Check the boxes for the features that you want to enable.
Note The Advanced Configuration selection refers to how SSIDs are assigned to RP
radios; see “Advanced Mode Configuration” on page 4-11.
4. Click the OK button.
Enabling the WLAN
RPs in your wireless network will not support the WLAN until you enable it.
To enable the WLAN, complete these steps:
1. Select Network Setup > WLAN Setup and click the Configuration tab.
2. Select the WLAN that you want to enable. You can use the
<Ctrl> key to
select multiple WLANs.
3. Click the Enable button.
The icon in the Enabled column should change from a red X to a green
check mark, as shown in Figure 4-45.