WESM zl Management and Configuration Guide WT.01.03 and greater

8-18
Configuring Network Address Translation (NAT)
Planning the NAT Configuration
Figure 8-7. Dynamic NAT on a Sample Network
For this NAT implementation, you would record the IP addresses specified in
the DHCP pool and configure an ACL that selects those addresses. Table 8-3
lists the actual IP addresses that you would record for the sample network
shown in Figure 8-7.
Table 8-3. Recording Addresses for Dynamic NAT on a Sample Network
NAT Interface Type
(Inside or Outside)
NAT Address
Typ e
Local or Global Address Recorded Addresses for the Sample
Network
Inside Source Local (stations’ IP addresses as they
appear on the wireless network)
10.1.1.0/24 subnetwork—assigned through
DHCP and specified in an ACL
Inside Source Global (IP address for all stations as
it appears on the wired network)
192.168.1.10—module’s vlan 1 IP address