WESM zl Management and Configuration Guide WT.01.03 and greater

10-22
Redundancy Groups
Configuring a Redundancy Group
Viewing Information about the Other Members of the
Redundancy Group
In addition to viewing information about the redundancy group, you can view
information about the other members of the group. Select Network Setup >
Redundancy Group and click the Member tab.
Figure 10-9. Network Setup > Redundancy Group > Member Screen
You can select a member and review the following information about the
selected member:
■ IP Address
■ State—what the module knows about this member
• Configured—The member is configured on the current module but no
additional information is known about the member.
• Seen—The module has exchanged heartbeats with this member.
• Invalid—The redundancy group settings on the member (including
heartbeat time, discovery time, hold time, redundancy ID, and redun-
dancy protocol version) do not match the configuration on this module.