WESM zl Management and Configuration Guide WT.01.03 and greater

12-21
Wireless Network Management
Monitoring the Wireless Network
The Information section describes this radio and shows the number of stations
currently associated to it. You should check the Current Channel listing; if the
radio is configured with a manual channel but currently uses a different
channel, the channel number is listed in red.
On the Details screen, statistics for wireless traffic are broken down into
received and transmitted traffic.
You can view the average status of the wireless medium or all stations
connected to this radio under RF Status:
■ Avg Station Signal (dBm)—average signal level detected for all stations
associated to the radio
■ Avg Station Noise (dBm)—average background noise in the wireless cell
■ Avg Station SNR (dBm)—average SNR for all stations associated to the radio
View the Errors section to monitor for congestion. Statistics include:
■ Avg Number of Retries—average number of retries the radio must make to
successfully transmit a packet
A high value (over 10 or 20 percent) may indicate excessive congestion
or interference from another wireless device.
■ % Gave Up Pkts—number of packets that the Wireless Edge Services zl
Module never successfully transmitted to a station associated to this radio
■ % of Undecipherable Pkts—percentage of packets received by this radio
that could not be deciphered
A high percentage might indicate that someone is attempting to guess a
static WEP key or WPA/WPA2 PSK.
The Details screen also allows you to simultaneously compare statistics for
the last 30 seconds and the last hour.
Viewing a Graph of Radio Statistics
The Wireless Edge Services zl Module can create a graph of statistics for a
radio, which displays how the statistics change over time.
To view this graph, follow these steps:
1. Select Network Setup > Radio.
2. Select the Statistics tab.
3. Select the radio.