WESM zl Management and Configuration Guide WT.01.03 and greater

12-43
Wireless Network Management
AP Detection
Figure 12-28.Enabling AP Detection and Configuring Settings
b. Check the Enable box.
c. Customize the timeout setting for approved and unapproved APs.
(For more information about approved and unapproved APs, see
“Creating Lists of Detected APs” on page 12-46.)
– Approved AP timeout—specifies how long the module retains infor-
mation about APs that you have defined as allowed.
– Unapproved AP timeout—specifies how long the module retains
information about APs that are not allowed.
Enter a time from 1 through 65,535 seconds (approximately 18 hours),
or accept the default setting of 300 seconds (five minutes).
d. Click the Apply button.
2. Configure a particular radio or radios to scan for APs.
a. Select Network Setup > Radio > Configuration.
b. Select the radio or radios.
c. Click the Edit button. The Configuration screen for the radio is dis-
played. (See Figure 12-29.)