WESM zl Management and Configuration Guide WT.01.03 and greater

12-60
Wireless Network Management
Configuring Station Intrusion Detection
4. Set a Radio threshold and a Wireless Module threshold for:
• Excessive Probes
• Excessive Association
• Excessive Disassociation
• Excessive Authentication failure
• Excessive Crypto replays
• Excessive 802.11 replays
• Excessive Decryption failures
• Excessive Unassociated Frames
• Excessive EAP Start Frames
Again, enter a number from 0 through 65,535.
5. In the Time to Filter field, enter a time from 0 through 86,400 seconds to
control how long the module will filter, or block, traffic from a station that
exceeds a threshold. The default time is 60 seconds.
6. Click the Apply button.
Configuring the Module to Report Station Intrusion
You can also configure the module to send an alarm when it detects station
intrusion. To configure this SNMP trap, complete these steps:
1. Select Management > SNMP Trap Configuration > Configuration.
2. Expand the Wireless heading and then the Intrusion Detection heading.