WESM zl Management and Configuration Guide WT.01.03 and greater

A-110
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
Example
Related Commands
show running-config (page A-151)
ap-detection
This command configures the periodic detection of nearby access points. The
no command disables ap-detection.
Syntax
ap-detection (approved | enable | max-aps | timeout )
no ap-detection
• approved - Configures the approved detection list.
– add - Add an entry to the approved AP list .
+<1-200> - Index where this approved entry will be added: <1-
200>.
- MAC - MAC address in AA-BB-CC-DD-EE-FF format.
++LINE - A string of up to 32 characters.
++any - Any SSID.
- any - Any MAC address.
++LINE - A string of up to 32 characters.
++any - Any SSID.
• enable - Allow radio-ports to look for APs.
• max-aps - The maximum amount of entries unapproved-seen and
approved-seen can show.
– <1-1000> - Number of entries between 1 and 1000.
• timeout - The amount of seconds a AP will remain in the list after it is
no longer seen.
– <1-65535> - Number of seconds between 1 and 65535.
Default Setting
Disabled
HPswitch#configure
HPswitch(config)#wireless
HPswitch(config-wireless)#advanced-config enable
HPswitch(config-wireless)#