WESM zl Management and Configuration Guide WT.01.03 and greater

A-112
ProCurve Wireless Services zl Module Command Line Reference
Wireless Commands
Example
ids
This command configures the Intrusion Detection configuration commands.
The no command negates the configuration.
Syntax
ids (excessive-associations | excessive-probes | filter-ageout)
no ids
• excessive-associations - Monitors the number of association requests
from stations.
– <0-65535> - Maximum number of association requests per second .
• excessive-probes - Monitors the number of probe requests from
stations.
– <0-65535> - Maximum number of association requests per second .
• filter-ageout - Se t the num ber of se c onds to f ilte r a s tation th at
set off IDS.
– <0-65535> - Time in seconds.
Default Setting
N/A
Command Mode
Wireless Configuration
Example
Related Commands
show wireless ids (page A-168)
HPswitch#configure
HPswitch(config)#wireless
HPswitch(config-wireless)#dot11-shared-key-auth enable
HPswitch(config-wireless)#
HPswitch#configure
HPswitch(config)#wireless
HPswitch(config-wireless)#ids excessive-associations 500
HPswitch(config-wireless)#ids excessive-probes 400
HPswitch(config-wireless)#ids filter ageout 40
HPswitch(config-wireless)#