WESM zl Management and Configuration Guide WT.01.28 and greater

2-13
Configuring the ProCurve Wireless Edge Services zl Module
Management Interfaces
■ running-config—When the Wireless Edge Services zl Module loads the startup-
config, all the configurations become part of the running-config, which is held
in RAM. When you make and apply configuration changes in the Web browser
interface, these changes become part of the running-config as well. Unless you
save the changes that you apply to the running-config, these changes are not
retained when the Wireless Edge Services zl Module is rebooted.
Applying Changes to the running-config. You can make and apply configuration
changes to the running-config in different ways:
■ Apply button—On some configuration screens, you make configuration changes
and then click the Apply button.
■ Enable button—In some instances, you enable functionality by clicking the Enable
button. To deactivate the functionality, you click the
Disable button.
■ OK button in Add or Edit screens—To add information or edit configurations,
you click the Add or Edit button, make configuration changes on the screen that
is displayed, and then click the OK button. (In some cases you can delete specific
configurations by clicking the Delete button.)
After you enter changes in a configuration screen but before you click one of these
buttons, you have the option of backing out, or deleting, the changes. To back out
changes not yet applied to the running-config, click the Revert button. (See
Figure 2-4.)
Saving Changes to the startup-config. To save configuration changes to the
startup-config and ensure that they are not lost when the Wireless Edge Services zl
Module is reloaded, you must click the Save link at the top of the screen.
(See
Figure 2-4.)
If you are using the CLI, you must enter the
write memory command to save changes
to the startup-config file. When you enter this command, you must be in the wireless-
services context. (For more information, see “CLI” on page 2-21.)