WESM zl Management and Configuration Guide WT.01.28 and greater

2-21
Configuring the ProCurve Wireless Edge Services zl Module
Management Interfaces
6. After you set the filter criteria, click the Filter Entire Table button. Only the
tunnels that match the filter are now listed on the screen. If you want, you can
refine your filter criteria and click the Filter Entire Table button again.
Note Throughout the Wireless Edge Services zl Module interface (whether or not you are
using filtering), you can sort data lines by clicking on the respective column headings.
For example, on the screen shown in Figure 2-8, you can click on the SSID column
heading to sort the data alphabetically by the SSID name. Click the heading once to
sort the column in ascending order (an up-arrow is displayed), and then click the
heading again to sort the column in descending order (a down-arrow is displayed).
Click the heading a third time to return the column to its original sort order (the arrow
will no longer be displayed).
7. When you are finished viewing the filtered results, click the Turn Off Filtering
button in order for all tunnels to be listed on the screen.
To hide the filtering options on the screen, click the Hide Filtering Options link.
Although the filter itself is hidden, the screen continues to display only the rows that
match the filter. To turn off filtering, click the Show Filtering Options link and then
click the Turn Off Filtering button.
CLI
You access the Wireless Edge Services zl Module CLI through the CLI for the
wireless services-enabled switch. You can access the switch CLI through:
■ serial session
■ Telnet session
■ SSH session
Accessing the Switch CLI Through a Serial Session
If you use a serial session to connect to the wireless services-enabled switch, use the
serial cable (5184-1894) that was shipped with the switch. Then run terminal session
software such as Tera Term or HyperTerminal on your workstation, setting the
following parameters for the session:
■ Baud Rate = 9600
■ Parity = None
■ Data Bits = 8
■ Stop Bits = 1
■ Flow Control = None