WESM zl Management and Configuration Guide WT.01.28 and greater

2-23
Configuring the ProCurve Wireless Edge Services zl Module
Management Interfaces
From the enable context, you can enter show commands to view information about
the Wireless Edge Services zl Module, and you can perform some operations such
as erasing the startup-config file and copying configuration files to and from the
module.
To make configuration changes, however, you must move to the global configuration
context. From the global configuration context, you can enter commands to change
settings, or you can access other contexts that allow you to change settings.
To move to the global configuration context for wireless services, enter:
ProCurve(wireless-services-C)# configure terminal
Again, the CLI prompt shows your new context:
ProCurve(wireless-services-C) (config)#
To view the commands available at any context, you can use a question mark:
ProCurve(wireless-services-C) (config)# ?
You can also use the question mark to view the options available for specific
commands:
ProCurve(wireless-services-C) (config)# ip ?
Saving Changes to the startup-config
When you make configuration changes to the Wireless Edge Services zl Module, you
must enter the write memory command to save these changes to the module’s startup-
config. When you enter this command, you must be in the wireless-services context:
ProCurve(wireless-services-C)# write memory
If you exit the wireless-services context and enter the write memory command in the
CLI for the wireless services-enabled switch, the configuration changes for the
Wireless Edge Services zl Module are not saved to its startup-config file.
CLI Commands
See Appendix A: “ProCurve Wireless Edge Services zl Module Command Line
Reference” for a list of CLI commands for the Wireless Edge Services zl Module and
their descriptions.