WESM zl Management and Configuration Guide WT.01.28 and greater

2-29
Configuring the ProCurve Wireless Edge Services zl Module
Management Interfaces
By default, the HTTPS server submits the self-signed certificate in the default-
trustpoint. The HTTPS Trustpoint drop-down menu includes this trustpoint and
any other trustpoint configured on the module.
The drop-menu also includes the <Create New Certificate> option. Select this
option to open the Certificates Wizard, which guides you through the process of
creating or installing a certificate. For more information about digital certificates
and the Certificates Wizard, see “Digital Certificates” on page 2-163.
5. Click the Apply button.
Note By default, users can reach the Wireless Edge Services zl Module’s Web browser
interface at any IP address configured on the module. Secure management forces the
module to open sessions only with users that destine their traffic to the module’s
management VLAN IP address.
To enable this option, check the Secure Management (or Management VLAN only)
box in the Management > Web Access Control screen. Then click the Apply button.
Choosing SNMP Versions
As described in “SNMP Support” on page 2-24, the Wireless Edge Services zl
Module supports both SNMP v2 and SNMP v3. By default, both versions are enabled.
You can disable either version.
For example, you might disable SNMP v2 to avoid sending management data in
plaintext. Before disabling SNMP v2, make sure that your SNMP server supports
SNMP v3 and that it knows the username and password for an SNMP v3 user
configured on the module.
Take care when disabling SNMP v3: because this protocol controls communications
between management stations and the Java applet, disabling SNMP v3 disables all
access to the Web browser interface. You must then configure the module through
the CLI. To re-enable Web access, enter this global configuration mode command:
snmp-server manager v3.
To enable and disable either (or both) SNMP versions, as well as to configure various
other options, follow these steps:
1. Select Management > Web Access Control.