WESM zl Management and Configuration Guide WT.01.28 and greater

2-48
Configuring the ProCurve Wireless Edge Services zl Module
Management Interfaces
Figure 2-24. Specifying the RADIUS Server To Authenticate Web-Users
b. Specify the server’s IP address in the Radius Server IP Address field.
c. Enter your server’s port in the Radius Server Port field.
Typically, enter 1812. The valid range is from 0 to 65535.
d. In the next field, specify the number of times that the module attempts to
connect the RADIUS server if it does not receive a reply.
For example, if you enter 3, the module attempts to reach the RADIUS
server four times, at the most. It then considers the authentication service
unavailable. The valid range is from 0 to 100.
e. In the next field, specify how long the module waits for a reply from the
RADIUS server before retrying (or, on the final retry, declaring the authen-
tication service unavailable).
The timeout value is in seconds; specify a number from 1 to 1000.
f. In the next field, enter the shared secret.
This string must match the secret specified for the Wireless Edge Services
zl Module in the list of clients on the RADIUS server.
g. Click the OK button.