WESM zl Management and Configuration Guide WT.01.28 and greater

2-66
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
Figure 2-35. Checking an RP’s Bootloader Code Through the Module’s Web
Browser Interface
With the new bootloader code, the RP can complete Layer 3 adoption. You can
now install the RP in its final location, and as long as you set up other
requirements described below, the RP will be adopted at Layer 3.
2. On your DHCP server, you can create a fixed configuration specifically for the
RP, or you can add option 189 to a pool already configured for other stations.
You can easily allow the RP to use the same pool as other stations. The DHCP
server does not send the 189 option unless the device requests it.
If, however, for whatever reason, you want to create a fixed configuration for
the RP, you should specify the RP’s Ethernet MAC address as the client ID. You
can find this MAC address on the undercarriage of an RP 210 or 230 or the top
face of an RP 220.
3. Whichever type of configuration you choose for the RP, add option 189 to the
configuration. For the option’s value, specify up to three IP addresses of Wireless
Edge Services zl Modules. Separate the addresses with spaces. For example:
Boot code