WESM zl Management and Configuration Guide WT.01.28 and greater

2-70
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
Figure 2-37. Verifying Layer 3 Adoption in the Device Information > Radio Adoption
Statistics
The screen should list the Layer 3 RP just as it lists other RPs. However, the IP
Address field shows the Layer 3 RP’s IP address. (This field shows N/A for Layer 2
RPs.)
Note The IP address is for informational purposes only. For example, you can ping the RP
at this address, but you cannot attempt to access or manage the RP.
Automatic or Manual Adoption of RPs
Once an RP can transmit traffic to the Wireless Edge Services zl Module, the module
can detect and adopt it. Automatic adoption simplifies deployment, especially if your
network includes many RPs. After the Wireless Edge Services zl Module adopts an
RP, it sends the radio adoption default configuration to it. You can then customize
settings for certain RPs. (To learn how to configure RP settings, see Chapter 3:
“Radio Port Configuration.”)
This RP was
adopted at Layer 3