WESM zl Management and Configuration Guide WT.01.28 and greater

2-77
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
Figure 2-44. Radio Configuration Radio Settings
Then enter a value from 1 to 65535 in the Adoption Preference ID field. Match the
ID that you set for the Wireless Edge Services zl Module that should adopt this RP.
Remember: RPs do not store their own radio configurations; they receive them from
a Wireless Edge Services zl Module. Therefore, you must create radio configurations
for each RP on each module, and you must set the correct adoption preference IDs
in these radio configurations. This allows the RP to receive the correct ID no matter
which module first detects its adoption messages.
For example, if your system includes two modules and 70 RPs, you must create the
same radio configurations for all 70 RPs on both modules. And on both modules, you
would set some RP radios to the first module’s adoption preference ID and some RP
radios to the second module’s ID.
You can create a radio configuration manually by clicking the Add button in the
Network Setup > Radio > Configuration screen and entering the RP’s Ethernet MAC
address. You can then edit the configuration and set the adoption preference ID to
match the module that should adopt that RP.
Set the adoption
preference ID to
match the module
that should adopt the
RP.