WESM zl Management and Configuration Guide WT.01.28 and greater

2-79
Configuring the ProCurve Wireless Edge Services zl Module
Radio Port Adoption
The default username and password on all ProCurve 200 Series RPs are admin and
procurve.
ProCurve Networking suggests that you use pre-adoption to change these settings,
using a Wireless Edge Services zl Module to load new credentials on your organiza-
tion’s RPs. You can then move these RPs to their final locations and be sure that only
these RPs can connect to your network.
Configuring 802.1X Authentication for RPs
To configure 802.1X authentication for RPs, complete these steps:
1. Select Network Setup > Radio > Configuration.
2. Click the Global Settings button. The Global screen is displayed.
Figure 2-45. Radio Global Settings Screen
3. Click the Configure Port Authentication button. The Configure Port Authentica-
tion screen is displayed.