WESM zl Management and Configuration Guide WT.01.28 and greater

2-83
Configuring the ProCurve Wireless Edge Services zl Module
System Maintenance
■ Built Time—This field reports the date and time that this software image was
created.
■ Install Time—This field reports the date and time that this software image was
updated on the Wireless Edge Services zl Module.
Selecting the Software Image That Is Used to Reboot
You can specify which software image the Wireless Edge Services zl Module will
use the next time it is rebooted—the primary or the secondary. Complete these steps:
1. Select Management > System Maint.—Software.
2. Select the software image that the Wireless Edge Services zl Module should use
to boot. For example, if you want the module to boot with the secondary image,
select that image.
3. Click the Edit button at the bottom of the screen.
Figure 2-48. Update Software Image Dialog Box
4. Check the Use this software on next reboot box, and then click the OK button.
5. Click the Save link at the top of the Web browser interface to save this change
to the startup-config.
Changing the Image Failover Setting
When the Wireless Edge Services zl Module reboots, it attempts to initialize the
software image that you have selected for the next reboot. If this attempt fails, the
module tries one more time to initialize the software image. If this second consecutive
attempt fails, by default the module automatically reboots using the other software
image.
If you do not want the Wireless Edge Services zl Module to automatically reboot
using the other image, you can disable this failover capability. Complete these steps:
1. Select Management > System Maint.—Software.