WESM zl Management and Configuration Guide WT.01.28 and greater

2-90
Configuring the ProCurve Wireless Edge Services zl Module
System Maintenance
Figure 2-54. Management > System Maint.—Config Files > Transfer Screen
3. In the Source section, specify the source as an FTP or TFTP server:
a. In the From field, use the drop-down menu to select Server.
b. In the File field, enter the name of the configuration file.
c. In the Using field, use the drop-down menu to select either FTP or TFTP.
d. In the Port field, if needed, change the port number for your FTP or TFTP
server. In most cases, the defaults (port 21 for FTP, port 69 for TFTP) should
apply to your server.
e. In the IP Address field, enter the IP address of the FTP or TFTP server.
f. If you are using an FTP server, enter the login credentials.
i. In the User ID field, enter the username for the FTP server.
ii. In the Password field, enter the password for this username.
g. In the Path field, enter the path where the configuration file is saved on the
server.
If you are using an FTP server and the configuration file is saved at the
server’s root level, enter a period followed by a slash (./). If the configuration
file resides at a different level on the FTP server, enter the complete path.
If you are using a TFTP server, this field may not be required. However,
enter the path if the file is stored in a subdirectory on the TFTP server.
4. In the Target section, specify the destination as the Wireless Edge Services zl
Module:
a. In the To field, use the drop-down menu to select Wireless Services Module.
b. In the File field, enter the name that you want to give to the configuration file.