WESM zl Management and Configuration Guide WT.01.28 and greater

2-97
Configuring the ProCurve Wireless Edge Services zl Module
System Maintenance
5. Choose the filename.
The path to the folder you have selected is displayed in the field at the bottom
of the screen. Files in this folder display to the right. You can select one of these
files and write over it, or you can choose a new file. To create a new file add the
filename to the path in the field at the bottom of the screen. For example: flash/
myfolder/configA.
6. Click the OK button.
7. The path and filename that you have selected are displayed in the File field.
8. Click the Transfer button. In the Status section at the bottom of the screen, a
message is displayed, reporting whether the transfer was successful.
Deleting a Configuration File
From the Management > System Maint.—Config Files screen, you can delete any
configuration file that is stored in flash—except the startup-config file. To delete a
configuration file, complete these steps:
1. Select the configuration file and click the Delete button. As shown in
Figure 2-61, you will be prompted to confirm that you want to delete this
configuration file.
Figure 2-61. Confirm File Delete Prompt
2. Click the Yes button to delete the file.
Note If you attempt to delete the startup-config file, the Web browser interface allows you
to go through the steps of deleting the file, but when you confirm that you want to
delete the file, the following message is displayed at the bottom of the navigation bar:
You have selected the system startup-config file. This file cannot be edited.
Rather than trying to delete the startup-config file when you are using the Web
browser interface, you should return the file to factory default settings, as explained
in the next section. (You can enter the erase command in the CLI to delete the startup-
config. The module then uses the factory default startup-config file.)