WESM zl Management and Configuration Guide WT.01.28 and greater

2-98
Configuring the ProCurve Wireless Edge Services zl Module
System Maintenance
Returning the Startup-Config File to Factory Default Settings
Although you cannot delete the startup-config file if you are using the Web browser
interface, you can return this file to factory defaults. Complete these steps:
1. On the Management > System Maint.—Config Files screen, click the Restore
Defaults button. A prompt is displayed, asking you to verify that you want to
return the startup-config file to factory defaults.
Figure 2-62. Restore Factory Defaults Prompt
2. Click the Yes button if you want to revert to factory settings. A prompt is
displayed, telling you that the Wireless Edge Services zl Module must be
rebooted in order for the change to take effect.
3. Click the Yes button to reboot the module.
Update Server
The Wireless Edge Services zl Module can communicate with an Update Server, on
which you can store backup copies of the software image and the configuration file
for your Wireless Edge Services zl Module. If the module’s software image or
configuration file becomes corrupted, you can reboot the module, and it will retrieve
the necessary file from the Update Server—provided you have configured the Update
Server settings correctly and copied the necessary files to the Update Server.
When you configure the Update Server on the Wireless Edge Services zl Module,
you define the following:
■ IP address of the Update Server
■ protocol of the Update Server (FTP or TFTP)
■ server username and password (for FTP server)
■ location of the software image on the Update Server
■ software image that the module should use
■ location of configuration file
■ location of a redundancy configuration file—a common configuration for an
entire redundancy group, an optional supplement to (not replacement for) the
configuration file